Water Bottles

Pressing instructions for aluminum and stainless steel water bottles:
(SKU 23600G23601G27872-G27873G)

PDF template for Adobe Photoshop
EPS template for Corel Draw | Adobe Illustrator

Mug Master Pro mug press

Idle Temperature: 275 F°
Press Temperature:
330 F°
Time:
15 seconds
Pressure:
 Aluminum - Light
                Steel - Medium

GeoKnight DK3

Pressing temperature: 400 F°
Time: 3 minutes
Pressure: Aluminum - Light
                Steel - Medium

4-in-1 Mug Press

Press temperature: 320 F°
Time: 
150-180 Seconds
Pressure: 
Medium/Firm

Sublimation Wrap

Press Temperature: 400 F°
Time:
10-13 minutes
(test in your oven for accurate time)

Pressing with Mug Master Pro mug press:

Use the water bottle element in the mug press for this item!
This will be the 1/2" thick straight element included in your package.

  • Tape the sublimation paper with image printed in reverse to the water bottle with thermal tape.
  • When the heat press reaches the idle temperature of 275 F°, you will hear a beeping sound indicating that the machine is ready. Place the water bottle in the element and close it by pulling the handle towards you. 
  • Press the green, round button to begin the pressing cycle.Temperatures may drop which is normal. Once the temperature reaches 330 F° the timer will begin counting down. 
  • Once the timer reaches 0, take out the water bottle from the press and remove the transfer paper immediately. Allow the water bottle to cool completely before use.

Pressing with the GeoKnight DK3 mug press:

  • Attach sublimation transfer paper with image printed in reverse to the water bottle with thermal tape.
  • Place water bottle in heat press at the pressing temperature of 400F, and close the element around the water bottle.
  • Press for about 3 minutes using light pressure for aluminum bottles and medium pressure for stainless steel. If the image begins to look blurry, or burnt brown by over-pressing, decrease pressing time by 15-30 seconds.
  • Once done, remove the water bottle from the press and remove the transfer paper immediately. You may allow to cool in front of a fan to prevent the image from bleeding.

Pressing with water bottle sublimation wrap:

  • Attach reversed printed image to water bottle with thermal tape.
  • Wrap silicone wrap around water bottle surface and clasp at handle.
  • Place in oven preheated to 400F for approximately 10-13 minutes (test to determine best timing!).
  • Afterwards, remove wrap and transfer immediately.
Share:
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request