Bottle Openers

Pressing Instructions for Sublimation Bottle Openers:

  • Temperature: 365F
  • Time: 120 secs
  • Pressure: Medium/Heavy
  1. Print image in reverse
  2. Check for protective film before pressing
  3. Place in heat press with transfer on top
  4. Press according to above time/temperature/pressure
  5. After pressing, remove paper immediately.

If printing the second side immediately:

  1. Flip item over
  2. Recover with new transfer
  3. Adjust timing to 90 seconds to print opposite side

Above instructions apply for the following bottle opener models:

Stainless Steel Sublimation Bar Bottle Opener Tab | 26880

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request