Polymer Plates

Pressing Instructions

  • Print image in reverse
  • Place object inside 3D vacuum bed
  • Place transfer image face down on object
  • Lay a small piece of paper or silicone rubber across the edge of the plate, on top of the transfer for even air suction
  • Temperature: 250 F
  • Time: 10 minutes
  • Remove paper immediately

Sublimation 8" Polymer Plate | SKU: 75273

*For Use in 3D Sublimation Press

Share:
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request